Sorry but this item is currently unavailable.
Please check back at a later stage.
The Heated Bet RetroFittable Kit is a Heated Bed Upgrade for those who currently own a "The Beast" V1.X+ 3D Printer. The heated bed runs off 110-240V power via an IEC 19 Cable (Not Supplied). For 110V Customers we recommend a 15A IEC 19 cable, for 240V Customers 10A IEC 19 cable is sufficient.
The Heated Bed is stand alone an requires virtually no wiring. Simply stick the Silicone Heatpad to the underside of the Borosilicate glass, fit the brackets in place (which support the additional weight of the silicone), then simply set the temperature, hit the print button and enjoy the benefits of greater adhesion control.
THe Heated bed runs directly from an included 110-240v power supply, without 12V conversion. This means you can get the bed extremely hot (over 180 deg C), the temperature is easily maintained (unlike 12 or 24V solutions) and the bed heats incredibly quickly - Your'e ready to print in as little as 20 seconds.
In the Retrofit upgradekKit :
1x Self Adhesive Silicone Heatpad inc power supply and thermistor.
2x Bed Extrusions (To fit between the Front Left/Right and Rear Bed Holders).
1x 5mm Borosilicate Glass Bed.
Customers please note. We use DHL Express as our international shipping provider. We have enabled free shipping for this item, however if your country is classed as Zone 7, 8 or 9 by DHL, there will be an additional shipping cost of $100AUD. One of our customer support representatives will contact you to arrange the additional payment once checkout is complete. To find out which shipping zone you are in, please refer to this document. http://www.dhl.com.au/content/dam/downloads/au/express/shipping/rate_guides/dhl_express_rate_transit_guide_au_en.pdf